Skip to content
LawnElm

Trees

Stump grinding: how deep it goes, what is left and what to ask

A grinder turns a stump into wood chips below the surface. The hole, the chips and the underground utilities are the three things to settle before the crew arrives.

By LawnElm Editorial Team Updated 6 min read

Priced by
Stump width and depth
Season
Any time after removal
Do it yourself?
Partly
Illustration: a stump grinder cutting a stump below the lawn surface with a pile of wood chips beside it

Short version

Iowa State University Extension says a grinder removes the stump and large lateral roots, typically down 8 to 12 inches, and leaves a large pile of wood chips in the hole. Hauling the chips and filling the hole are usually extra. Ask the crew about 811 utility locates before the work, and put the grinding depth, the chips and the fill in the written quote.

What stump grinding is

After a tree is cut down, the stump and its roots are still in the ground. Stump grinding uses a machine with a rotating cutting wheel to chip the stump away. It is the job that usually follows tree removal, and many tree companies sell it as an add-on to a removal, according to the University of Illinois Extension.

Iowa State describes grinding as the quickest, easiest and safest way to remove a stump, with little manual labor, and says the stump is gone within a matter of hours. The roots are not all removed. The grinder takes the stump and the large lateral roots near it, and the rest of the root system stays in the ground and decays.

How deep it goes and what is left

Iowa State says grinding typically goes down 8 to 12 inches. The University of Illinois describes the range as anywhere from flush with the soil line to over a foot deep, and says the deeper you want it, the more it will cost. Agree the depth in writing before the work starts.

  • Chips: Iowa State says a large pile of wood shavings remains in the hole. Removing the chips and filling the hole are typically extra services.
  • Soil mix: the University of Illinois says the grindings are usually mixed into the soil as the blade works, and that you may be left with a large hole.
  • Planting over it: both universities say the wood can get in the way. Iowa State says left in place, chips can make it hard for turf or plants to grow. Illinois says wood in the soil can tie up nitrogen as it breaks down. Their advice is to haul off the chips and fill with good topsoil before planting.

Season, by belt

The extension publications read for this page do not tie grinding to a month, so the work follows the tree. A stump can be ground once the tree is down. What changes with your belt is the lawn repair afterwards, because seed and sod go in when your type of grass is growing, which differs between the cool, transition, warm and dry West belts. See lawn seeding and overseeding and sod installation for the timing, and your state page for your belt.

Live stumps also resprout. The University of Illinois says live stumps often sprout from the stump or nearby roots and suggests following label directions for any chemical treatment of the fresh cut. Grinding removes the stump above the roots, but suckers can still come up from roots left in the ground.

Call 811 first

The national 811 service says anyone who plans to dig should contact it a few business days before starting, that the service is free, and that shallow digging still needs a call because some utilities are buried just inches down. Its list of projects includes planting trees and shrubs and installing fences and mailboxes.

The 811 page does not name stump grinding, and the Iowa State publication does not mention locating utilities. A grinder works below the surface, so ask the crew who places the locate request and whether your state counts grinding as digging. Your state 811 center can answer, and the call 811 guide explains the process. Wait for every utility to mark its lines before the machine comes.

Measuring and what a quote is built on

Iowa State says arborists charge based on stump size, measured at its widest point. Measure across the stump at that point, and count every stump, since each one is a separate item. Note any stump next to a fence, wall or slab, because tight access changes the work. LawnElm publishes no prices; the yard budget tool adds up the quotes you type in.

  • Number of stumps and the width of each at its widest point
  • Grinding depth below the soil surface
  • Whether chips are hauled off or left, and who removes them
  • Whether topsoil fill, leveling and seed or sod are included
  • Who calls 811 and when
  • Insurance certificate sent by the insurer or agent

If you plan to seed or sod the patch, the lawn supplies calculator turns the size of the area and the label coverage into amounts, and lot to lawn helps with the area.

Mistakes to avoid

  • Planting into the chips. Both Iowa State and Illinois warn that the wood changes the soil.
  • Skipping the locate. The 811 service says not contacting it is the top driver of damage to buried utilities.
  • Reaching for herbicide to speed decay. Iowa State says natural decay can take 10 years or more, and 1 to 3 years with accelerated methods, but it advises against herbicides for that purpose and against picloram. Read the label of any product, which is the legal direction for its use.
  • Hiring without a written scope. See tree service licensing and insurance for what to ask a crew.

Do it yourself or hire it out

Partly. The grinding is the part to hire. A grinder removes the stump in hours, and Iowa State calls it the safest method. What you can do yourself is the work around it: choosing the depth, hauling the chips, filling with topsoil and repairing the lawn. Waiting for the stump to rot is also a choice, but Iowa State puts the natural timeline at 10 years or more.

Questions people ask

How deep does stump grinding go?

Iowa State University Extension says typically 8 to 12 inches, which also takes the large lateral roots. The University of Illinois says it ranges from flush with the soil to over a foot deep, and that deeper costs more.

Are the wood chips removed?

Usually not unless the quote says so. Iowa State says a large pile of shavings remains in the hole and that hauling them off and filling it are typically extra. Chips left in place can make it hard for turf or plants to grow.

Do I need to call 811 before stump grinding?

The 811 service says anyone who plans to dig should call a few business days ahead, and the call is free. It does not list stump grinding by name, so ask the crew and your state 811 center. See call 811 before you dig.

Can I plant a tree in the same spot?

The University of Illinois says wood left in the soil can tie up nitrogen, which makes it hard to grow lawn or other plants there. Haul off the chips and fill with topsoil first, and ask an extension office about the tree itself.

Will the stump grow back?

Live stumps often resprout from the stump or nearby roots, says the University of Illinois. Grinding removes the stump, but sprouts can come up from remaining roots.

Sources

Depths and rules come from the publications above and were checked on November 20, 2026. Your state 811 center and county extension office can say what applies locally.